http://mikrokopter.de/images/deu.gif Seite in Deutsch

http://mikrokopter.de/images/fra.gif Page en fran├žais

Quadro Power Distribution

http://gallery.mikrokopter.de/main.php/v/tech/QuadroPowerDistribution.gif.html

http://gallery.mikrokopter.de/main.php/v/tech/QuadroVerteil_BL.jpg.html

Assembly of the Molex connector

http://gallery.mikrokopter.de/main.php/v/tech/molex1.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/molex2.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/molex3.jpg.html

Assembly of the bridges

8 bridges have to be assembled on the distribution board.

http://gallery.mikrokopter.de/main.php/v/tech/bridges1.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/bridges2.jpg.html

check for shortcut

The bridges may not have contact against each other or against plus or minus

http://gallery.mikrokopter.de/main.php/v/tech/messen2.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/messen1.jpg.html

Measure with a multimeter: against each other and against plus and minus it must have high resistance

Solder Elkos

The BL-Ctrls are connected via the wires of the Elko (capacitors). The Elkos are assembled from the top of teh distribution board.

The Elko-wires are to be bent over and put (and soldered) through the + and - solder-pads of the BL-Ctrls.

/!\ MINUS (marked on each Elko) goes to the outer sides - do not mix plus and minus here!

/!\ a lot of heat has to be used on the distribution board to make a perfect connection

http://gallery.mikrokopter.de/main.php/v/tech/ElkoLoeten.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/ElkoNachloeten.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/hochbiegen.jpg.html

Solder these pads from both sides of the distributor!

I2C connections

http://gallery.mikrokopter.de/main.php/v/tech/I2C_Bruecken.jpg.html http://gallery.mikrokopter.de/main.php/v/tech/I2CLoeten.jpg.html

connect C & D to the BL-Ctrls

Power and Buzzer

http://gallery.mikrokopter.de/main.php/v/tech/Buzzer.jpg.html

Connect the batterie cable

  • plus = red
  • minus = black

/!\ do not mix plus and minus here!

Connect the Buzzer

  • Buzzer plus = red cable = "Buzz"
  • Buzzer Minus = black cable = "minus"

http://gallery.mikrokopter.de/main.php/v/tech/Summer_001.jpg.html

connect the FC

http://gallery.mikrokopter.de/main.php/v/tech/FC21_+an_Verteiler.jpg.html

http://gallery.mikrokopter.de/main.php/v/tech/QuadroVerteil_fertig.jpg.html

http://gallery.mikrokopter.de/main.php/v/tech/FC-kabel.jpg.html



KategorieAnleitung KategorieEnglish